DIY Hanging Planter
We have a very large wood stash taking up the rafters, and two corners of the garage. I have decided to use some of the wood for simple projects that I can do myself. I let my outside projects be much more rustic than the indoor projects. The outside projects don’t need to be as sanded, the cuts can be straight, and I am not nearly as fussy so outdoor projects are perfect for me to practice woodworking.
The first step was digging through the wood to see what was available. I found a 2 by 12, some 1 by 4, and a piece of 3/4 inch plywood, I was able to save the pallets for a larger project.
The wood on the bottom left is the lumber I selected for making the hanging planter.
DIY Wood Plant Hanger Tutorial
To make this DIY Hanging planter you can use whatever wood you have on hand. I hope you can make this hanger out of odds and sods of wood cluttering your garage. If you don’t have 1 by 4 wood, 2 by 4s will work. You just need to make sure the base of the hanger is wide enough to keep the stand upright once the plant is added. If you don’t have a 2 by 12, you can use two 2 by 6 lumber, and so on. For the remainder of this post, I will share how to make the one shown.
I cut my wood into the following lengths.
1 – 2 by 12 cut to 24″ long
3 – 1 by 4 cut to 20″ long
2 – 1 by 4 cut to 34″ long
Start by building a box with the 1 by 4 lumber. To prevent the lumber from cracking while screwing the boards together, pre-drill the holes using a 1/8″ bit first, then add the 1 1/2 inch screws.
Drill the first hole and then add the screw to keep it in place, then drill and add the second screw. Do this on all four corners.
Add a second layer of 1 by 4 to the top of your box frame, this will add needed strength and thickness to the top of the frame. Drill and screw in place.
Add Screw Eyes for Hanging
If you are making the hanger for a plant basket, you only need to place one large screw eye in the middle of your hanger. As I am going to use this frame to hang a plywood sign (ex. A Welcome Sign, Fall Harvest Sign or Halloween Decor Sign) attach 3 screw eye hangers one in the middle for the plant and two at the ends for a sign.
The easiest way to attach the screw eyes is to make a tiny drill hole to start the screw eye. Then twist it in by hand until the screw eye bites into the wood. Then insert a screwdriver into the screw eye as leverage, this makes it incredibly easier to twist in.
Now that your box is made, center it over the 2 by 12 base. Predrill and then add a screw into each corner.
Finishing the DIY Plant Hanger
Hanging the Potted Plant
The commercial plastic pot hanger looked really ugly in the hanger. Check out the huge hook at the top. Today’s post is a bit late because I decided to make a quick macrame hanger to replace the ugly plastic one before taking the pictures. I will share the tutorial for the hanger later this week.
This little hanging planter did not use up much of the wood stash, I have thought of two more wood projects to try. Wish me luck in finishing them on my own.