DIY Outdoor Bench with Soft Cushion Back

Sharing helps my blog grow

Make a Comfy DIY Outdoor Bench

This bench was made to fit into a small front porch.  It needed to be small enough to leave room for safe entry, large enough to sit on, and comfortable.  Our neighbourhood has several Moms who sit out in their front yards visiting while the community children play.  I am hopeful that I will find some time to sit out front and join in.
a

small front porch, small front porch ideas, cheap front porch decor, diy front porch decor.

a
Hubs and I made this bench from Ana White’s Rugged Bench Tutorial.  We cut the 12″ board for the seat to 36″, the rest of the tutorial we followed exactly.  I love this bench because its different, its made from solid wood, it will take the punishment of being outdoors and it costs about $20 to put together.  The paint is a Tiffany Blue Sherwin Williams Exterior paint I had made at Lowes.

The bench is comfortable; the  rod iron railings not so much.  I originally thought of tying on two cushions but changed my mind.  Instead I made one large cushion 16″ by 36″.

Here is the tutorial on how to make your own cushion back.

Pillow Insert

I wanted a very particular sized cushion to match the width of the bench and the height of the rod iron railing.  Instead of trying to find a pillow form its much easier and quicker to make your own.

Cut two pieces of muslin 18 by 38 inches

Iron and then place good sides facing each other.

Sew around three seams, for the final seam leave a 6 inch gap open for stuffing.  Turn the fabric right side out and iron.

Add the fiberfill stuffing (I reused some from old cushions) and then sew the opening closed.  Its not a glamour photo but here is how the insert looks finished.
a

DIY Bench, DIY Bench Cushion, Outdoor Bench Ideas

 

Make the Cushion Cover

Cut two pieces of the cushion material 18″ by 38″.

Cut 8 strips, 4″ by 15″ long.

Fold the strips over and run a narrow seam around 3 sides, leaving one narrow end open.

To make the tie ons, turn the strips right side out by working the fabric up through the open end.  Iron well.

Create the Coffee and Flowers Stencil

When stenciling onto fabric I prefer to use freezer paper, unfortunately I had ran out.   I have vinyl and stenciling material in my stash but its not worth using on such a simple stencil. My stash has a whole stack of inexpensive plain white card stock paper so I used that instead.  Doing it with card stock is about $10 cheaper.

Using 3 pieces of 8″ by 11″ cardstock make a stencil.  My stencil was made using Honeyscript font and the pixel size is 480.

To hold the centers of the o,f,e etc. I taped them into place on one side.  I will remove the tape while painting.
a

DIY Stencil, DIY bench cushion, DIY outside cushion, DIY outside bencha

Tape the stencil to the fabric making sure it is square and centered.

Filling in the Letters with Paint

This is really easy to do and I love the water colour look.  Take 1 tbsp of grey chalk paint, add 1 tbsp of water and mixed them together.  If you don’t have chalk paint you can use regular acrylic paint and fabric medium.

Load the brush and remove most of the paint on the side of the container before applying the paint to the fabric.  Carefully brush onto your stencil starting on the paper and working towards the center.  Never paint from the center to the outside.  This reduces the chances of leakage and uneven letter edges.

Make sure to do the parts of the centers (o,f,e) that you can, keeping the tape in place.   At this stage the letters do not have to be filled completely, the goal is to make the outline legible.
a

DIY Stencil, DIY bench cushion, DIY outside cushion, DIY outside bench

a
Hold the letter centers in place (I pushed on mine with a large needle) remove the tape.  Apply paint where the tape had been.

Remove the stencil.  With a dry brush carefully spread the paint around to fill in the letters. Apply  more paint if needed, but you will likely be able to use the paint already on the material.  Let it dry thoroughly. Once dry set the paint by sealing it with a hot iron.

Assembling the Cushion

To attach the tie ons. Take the non stenciled piece of material.
a

DIY Bench, DIY Bench Cushion, Outdoor Bench Ideas
a
Pin two tie ons open edge to the seam and tails towards the center.  For the top of the cushion place the ties on four inches in from the edge and one in the middle.

For the bottom of the cushion place two strips in the center of the cushion.  Sew them into place and place back on your table.

To add the stenciled cushion front.
a

cushion stenciling, sewing DIY Bench, DIY Bench Cushion, Outdoor Bench Ideas

a
Take the painted front of the cushion and place face down with the top of the letters towards the top of the cushion where the three tie ons are.  Make sure to keep all of the tie ins facing the center of the cushion, pin.  Sew three seams, both longs side and one short side.

Insert the large cushion.   The final seam can be turned in and fastened with micro fleece or snaps.

Water Proofing

As this is going outside I Scotch Guarded this cushion.   I am going to test the Rust-Oleum Never Wet Outdoor Fabric Sealer.   But I haven’t purchased or applied it yet.  If any of you have used it, please let me know your thoughts.

This bench is part of my Small Front Porch Ideas for Summer days post.
a

small front porch ideas, diy front porch decor, front porch sitting area,

small front porch, small front porch ideas, cheap front porch decor, diy front porch decor.

a
The time it took to make this project is so worth it.  Its wonderful to just sit outside enjoy our all to short summers, unplug from the internet for a bit and enjoy the neighbourhood.

Hope you love it as much as I do.  Please share this post with your friends.

Sharing helps my blog grow

21 thoughts on “DIY Outdoor Bench with Soft Cushion Back

  1. I love this project since you can customize it to fit the dimensions of the space. If you have a special idea or an odd size it is easier and less stressful to make it yourself.

    1. Absolutely Debra. You the original Ana White Bench was shorter than ours, but to lengthen it all you had to do was cut the 12″ board longer. Same for the cushion and it really is super simple to sew.

      Thanks for the feedback, it is much appreciated.

  2. Oh this is gorgeous!! I would love to have this on my front porch. And that color- as a side note, I’ve been going crazy looking at paint samples for my kitchen (as an accent color), and I am TOTALLY going to get a sample of this Tiffany Blue! Thanks so much for the recommendation, I think you just helped me solve my problem LOL.

    1. Randi I asked the people at lowes to match a piece of tiffany blue that I had. If you want let me know know and I will take a picture of the top of the can if it helps.

    1. Hi Cristina. Thanks for commenting. The idea came from problem solving, a small sitting area is much cheaper than a bigger deck lol.

  3. This is so beautiful Leanna, I absolutely love this colour and the sweet cushion for the back is a great idea! Wishing you a fun summer time, enjoy your pretty porch!!

    1. Hi Katrin: Thank you. Pup and I sit out there for short periods, we both love watching whats going on. Its so nice to be outdoors in the sun again.

      As always your feedback is valued and appreciated.

  4. I really loved this little bench when I saw it last week Leanna. It’s the perfect color and fit for your tiny porch. The way you’ve made and hung the pillow at the back is pure genius too.

  5. Leanna I really like that you added the cushion on the back like that. I know at the end of the day when I sit down I want to lean back and relax into a soft cushion not a hard surface. You have done a great job!

Leave a Reply

Your email address will not be published. Required fields are marked *

CommentLuv badge